With the rapid growth of production and consumption in China's metal industry, sheet metal processing technology has also developed rapidly, especially the advent of metal laser cutting machines, which has brought an unprecedented leap in sheet metal processing.
How to adjust the laser cutting machine to make it cut faster and better?
In fact, the machine, like people, needs regular maintenance to maintain a relatively good operating state. If the machine is slow or bad, there are actually ways to adjust it. Today I will introduce you to several methods to improve the cutting effect and speed of the laser cutting machine.
First, debug laser cutting machine parameters to improve machine cutting speed.
Machine parameter setting is one of the main reasons that affect the cutting speed of the machine. In general, if the parameters are not adjusted well, its cutting speed will not work. The parameters are like the related actions of a series of actions such as driving, starting, accelerating, etc. If the parameters are not set, just like when you start the car, you hang a second gear to start. There will be jitter. When adjusting this parameter, generally pay attention to the following places:
1. Initial speed: As the name implies, this setting is the speed at which the machine starts, like the speed at which the car has just started in the process of driving. Many customers have such misunderstandings, thinking that the greater the initial speed, the better, but in fact this is wrong. If the initial speed of the laser cutting machine is set too high, the machine jitter will be very large.
2. Acceleration: Acceleration means the speed of the throttle during the driving of the car. It is the time it takes from the initial speed to the normal cutting of the machine. When the machine is cutting different patterns, it is a process of continuous start and stop. If the acceleration is set too low, the machine will cut slowly.
Second, adjust the machine assembly to improve the cutting effect of the machine.
1. Guide rail installation: The guide rail installation should be parallel. If the installation is not parallel, the machine will have resistance when it runs. Therefore, the installation of the two guide rails in the Y direction must be two parallel lines, and there must be no error between them.
2. The installation position of the beam and the coupling is not good. When the machine beam and coupling are installed, the screws are not locked, or there is a slant when they are locked, etc., it will happen.
Therefore, during the daily use of the laser cutting machine, the precautions must not be ignored, and the laser cutting machine should also be regularly maintained so that the equipment can run longer.
